Thick-walled slides and shaft-supporting columns running on largely dimensioned guideways coated with low-friction Turcite.
|
Positioning of all shafts as a continuous axis done by means of ball-screws, encoders and geared motors. Optional: Rapid axes positioning by brushless motor for reducing the tool change-over times.
|
Splinter screen “Jolly” preventing any splintering on all tools on the tenoning machine.
|
Tenoning table driven by means of brushless mo-tors via a rack having inclined toothing, a geared epicycloidal box for reducing the play, sliding on recirculating ball slides. This specific technology enables high speeds up to 90 m/min.
|
Gripper and downholder for vertical and sidewise clamping of the workpieces.
|
Possibility of tenoning 2 pieces at the same time.
|
Possibility of external profiling of the window-frame on the tenoning machine. This system allows perfect squaring of both sides of the window-frame.
|
Automatic unloading and introduction of both pieces into the profiling station.
|
Left-hand multi-tool shaft either of 130 mm height, lowerable under the table surface.
|
Glass bead recovery unit with automatic pull-out device.
|
Glass bead recovery unit with automatic pull-out device.
|
Possibility of equipping the machine with horizontal shafts for machining the upper or the lower sides of the workpiece.
|
Possibility of installing a motor-driven roller-table at the output end of the profiling unit.
|
Possibility of installing a workpiece loader. In such a case the machine can work in automatic mode without any operator in a complete frame-manufacturing line.
|
Device for lowering the bead.
|
Sitemap
